MG996R - 180 degree metal gear servo

Don't strip your servo gears under high load conditions! This metal geared digital servo features 6061-T6 aluminium gears and shaft and can handle up to 11kg.cm torque. The motor and the gearing has been upgraded from the previous version to improve performance in dead banding and centering accuracy. This servo can rotate 180 degrees (90 in each direction) and at peak performance under no load takes less than a second to do so!

They work great with our UltraBorg servo and ultrasonic control board, and other Raspberry Pi Motor Controllers.

Supplied with a 30cm cable with a 3 pin 2.54 female header connector that fits most receivers, including Futaba, JR, GWS, Cirrus, Blue Bird, Blue Arrow, Corona, Berg, Spektrum and Hitec.

It comes with a selection of horns and arms and screws which allows it to be used in various projects.

Features and specifications:

• Fast response motor with metal gearing
• 40.7×19.7×42.9mm
  
• Operating Voltage : 4.8 to 6.6V
• Max rotational speed: 0.15 seconds to turn 60 degrees (No Load @ 6.0V)
  
• Running Current 500mA - 900mA @ 6V
• Stall Current 2.5A @ 6V
• Stall Torque: 11 kg/cm @ 6V
• Stall Torque: 9.4 kg/cm @ 4.8V
  
• Operating Temperature Range: 0 degrees celsius to 55 degrees celsius
  
• Double Ball Bearing Design reduces shock on gears from impacts
  
• 30cm cable. We have servo extension cables if you need them
  
• Weight : 55g
• Dimension Sheet

Wiring Guide:

• Red: Battery Positive  
  
• Brown: Battery Negative  
• Orange: PWM Signal

Getting Started with UltraBorg & Servos.