PiBorg is still open and we are still shipping orders.
We expect orders may be delayed by a day or two due to COVID-19.
ZeroBorg Triple Stack (9V Soldered)
ZeroBorg - Troubleshooting
Oct 17, 2017
Installation issues
Permission denied, file not found, 404 or similar:
There are a few possible causes of this:
Out of disk space:
We have occa..
ZeroBorg - Specification
Oct 17, 2017
Quad motor controller
Power input Voltage 2.7-10.8V
Power output Current Max 1.5A per channel continuous
Power switch and emergency power off switch co..
ZeroBorg - Getting Started
Oct 17, 2017
Installation
Mounting
Two basic mounting options are provided:
The first option is to mount the ZeroBorg underneath of a Raspberry Pi Zero using the four..
ZeroBorg - Examples
Oct 17, 2017
Main Examples
Download and installation instructions can be found on the getting started tab, as well as wiring instructions for the motor(s) and power.
The..
ZeroBorg - Overview
Oct 17, 2017
The ZeroBorg is our new add on board for controlling motors using the incredible $5 computer the Raspberry Pi Zero.
The ZeroBorg with a Pi Zero and.. The ZeroBorg is our add on board for controlling motors using the Raspberry Pi Zero. It's small size means it fits neatly below a Raspberry Pi Zero and opens up endless possibilities for tiny robot designs.
The ZeroBorg can control up to 4 motors independently and is stackable via I2C, so you can keep adding ZeroBorgs (and our other compatible I2C boards) to control additional motors!
ZeroBorg is fully customisable, so you can match your ZeroBorg to your project you're making! The following optional add-ons are compatible with the ZeroBorg:
- A 5V DC/DC regulator to power the Pi as well as the motors,
- An infrared sensor to control the motors via an infrared remote control,
- A 9V battery clip to power the Pi and the motors.
This triple stack has three ZeroBorgs pre-programmed with different I2C addresses ready to control up to 12 motors! (9V Battery Clip Pre-Soldered). Includes:
- 3 x ZeroBorg Motor Controllers
- 1 x 5V DC/DC regulator which powers the Raspberry Pi Zero (Pre-soldered)
- 1 x Infrared sensor allowing control from most TV remotes (Pre-soldered)
- 1 x 9V battery clip (PP3) for powering the Raspberry Pi Zero and the ZeroBorg (Pre-soldered)
- Two female I2C headers to allow communications between the three boards (Pre-soldered)
- 1 x Secondary I2C header* for daisy chaining to other boards such as our UltraBorg or ThunderBorg (Not Soldered)
*Supplied with the daisy-chain header loose
Click on the "Related Products" tab to see the full selection of ZeroBorgs in all their glory!
ZeroBorg Specifications
Each ZeroBorg has:
- 4 full H-Bridges
- Capability of driving 4 motors or 2 stepper motors
- 2A peak or 1.5A RMS per bridge
- An on board fast blow fuse at 5A
- Designed to run off a 9V power source Max range 2.7V to 10.8V (To power the RPi Zero 7V minimum)
- 2 analogue inputs, which are great for sensors
- I2C communication, allowing daisy chaining to other boards
- Fully soldered and ready to use.
* Raspberry Pi 4 - Model B compatibility:
We have tested ZeroBorg with the Pi 4 and it works fine, however the 5V supply does not fully meet the Pi 4's 2.5A specification.
