My Account

Wish List (0)

UltraBorg - Specification

Written by in Build, UltraBorg - Build on .

Specifications

5V supply line voltage ratings


When not jumpered to RPi

  • 5V input nominal 4.8 to 6.5V (4xAA batteries)
  • 5V input maximum -0.3 to 17.0V
  • Also consider ratings of Servos and Ultrasonic modules

When jumpered to RPi, use min/max Pi voltage ratings.

IC designations

  • PIC16F1828-I/SS
  • Toshiba 16bit PWM IC TC62D723FNG

Ultrasonic supports Trigger and Echo on separate lines such as the HC-SR04 module.
30Hz/60Hz/120Hz Servo operation (Preconfigured to 30Hz. Changing requires Pic reprogramming with PicKit of Program code and Configuration registers

Toshiba TC62D723FNG datasheet
UltraBorg Schematic diagram
Pic Microcontroller datasheet
 

PIC source code

The code running on the PIC micro-controller can be downloaded here:
http://www.piborg.org/downloads/ultraborg/UltraBorg.X.zip
This code was built with MPLAB X v2.00 and the XC8 compiler at v1.30
The PIC can be programmed via the five pin header, pin 1 is marked with a triangle.
We recommend using a PICKit 2 for programming the board.

Last update: Oct 27, 2017

Related Article

Related Products

Comments

Leave a Comment

Leave a Reply

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.