My Account

Wish List (0)

LEDBorg - Build LEDBorg - Build Feed

LEDBorg - Build

Written by in Build, LEDBorg - Build on

Installation First you should make sure the Raspberry Pi is not powered (none of the LEDs are on). Now plug the LedBorg in to the GPIO header, making sure the PiBorg logo is towards the centre of the Raspberry Pi as shown below: If you previously installed the driver based version of LedBorg you can stop it from loading by using the command: sudo update-rc.d...

0 Comments

Written by in Build, LEDBorg - Build on

Capabilities The LedBorg provides a tri-colour LED controllable from the Raspberry Pis GPIO header. Using simple on / off logic it can provide a total of seven colours as well as off. Using software based pulse width modulation (PWM) it is capable of many more colours, around a million in fact. GPIO pins The LedBorg uses the following GPIO pins: RPi pin WiringPi pin LedBorg use ...

0 Comments

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.