With PicoBorg, you can turn on and off fans, motors, solenoids, relays etc. from your Raspberry Pi.

There are 4 low side drivers so you can turn on and off 4 devices
One is connected to the RPi PWM pin, so you can vary duty cycle (normally vary speed).

Only £5.99 or Available with cables for £9.99

Example uses

• 4 fans on/off control over all and vary speed on one fan
• 4 solenoids
• 4 DC motors (on / off control over all and vary speed on one motor)
• or a combination of these
• or control one 6 wire stepper motor in both directions

Voltage and current range

Max 20V recommended 12V or less
Max current 2.5A (stall) or less
Continuous current recommended <= 1A

Uses GPIO pins
GATE 1 - GPIO_4
GATE 2 - GPIO_18_PWM*
GATE 3 - GPIO_8
GATE 4 - GPIO_7

*alternate pin GPIO_25 via R1 / DNF resistor change

Please read the warnings in the Specification section.