ThunderBorg is a powerful dual motor control board for making awesome robots from your Raspberry Pi.
- Control big or small motors
- On-board 5V regulator powers the Raspberry Pi
- Runs from any battery pack or power supply from 7V to 35V
- Proper 5A output per motor connection
- Speed control forwards and reverse
- On-board voltage monitoring for attached batteries
- Mounts directly onto most Rasbperry Pi models
- Super bright LED capable of over 16 million colours
- Plug in more boards to control up to 200 motors!
- Controls 4, 5 or 6 wire stepper motors
Optional ThunderBorg Lid adds even more functionality.
- A second super bright LED which can be independently controlled
- 9V style connector for either AA battery packs or 9V batteries
- Convenient power switch to disconnect the batteries
- Enough room to sit a 10x AA battery pack
- Pre-soldered directly onto the ThunderBorg by us :)
Most models of Raspberry Pi can be connected directly to the ThunderBorg without cables:
This includes:
- Pi Zero (both v1.2 and v1.3)
- Model B+
- Pi 2
- Pi 3
Any Raspberry Pi can be connected by cables instead, including older models of Raspberry Pi:
Raspberry Pis that need to be connected by cable:
- Model A
- Model A+
- Model B rev 1
- Model B rev 2
Also the on-board LED can also be set into battery monitoring mode, allowing you to see how much power your robot has left:
Comments
Leave a Comment
Leave a Reply